6/20/2023 0 Comments Etherwake vs wakeonlan![]() ![]() To use this integration in your installation, add the. Important: I am using using MAAS DHCP for my entire network so I can browse internet from my cell phone with MAAS DNS. There is currently support for the following device types within Home Assistant: Switch. There is no firewall between MAAS, Node and Mobile. Main Issue: Node wake-on-lan 100% working from my mobile app but MAAS not sending magic packets to node from step one. I found the package 'etherwake' that could do the job if I'm ssh'ing to my openwrt router in order to launch the command. Now I checked "Commission" from menu but commissioning not pulling additional information from node (node is off because MAAS not sending magic packets to node's wake-on-lan) but if I switch on my node by my self through my mobile app after showing lots of lines once again node power down then node showing me 'Ready' status in MAAS but when I check node CPU and RAM details, it's showing me 0MB 0CPU.Īfter completing above task MAAS showing me node status is ready and then I tried to start node from MAAS it says "The action "Commission selected nodes" could not be performed on 1 node because its state does not allow that action." Hello, I'm looking for a way to use WakeOnLan, from WAN, to wake up my desktop computer. Wake-on-lan details are already configured on node and just to make sure if everything working fine I tested Wake-on-lan function from my mobile phone app and its working without any problem. The Wake on LAN (WOL) feature wakes a computer from a low-power state when a network adapter detects a WOL event. Then anyway etherwake can only work in LAN so cant be used since the WSL2 isnt in the same LAN: it would have to be bridged, not routed. Im trying to use wakeonlan to send a magic packet. In the node's BIOS, I did change the boot order so that it boots from the LAN and node successfully booting up from PXE boot from the MAAS cluster controller through atuo detect node function and MAAS DHCP server giving IP address from its DHCP range to node (In this process first time I switched on the node from its power button not from MAAS)Īfter completing above process the machine is now showing "declared" in MAAS and node automatically power down. I completed the post-install tasks like installing MAAS, configure network, DHCP-DNS, creating logins, importing boot images as explained here: The command and package to initiate this magic is as follows: etherwake. I setup MAAS Server in VM using Ubuntu 14.04 LTS. switch on automatically requires a technology called Wake on LAN (WOL). ![]() However, UDP is recommended because it can be generated without raw sockets which come with security restrictions, and port 9 is recommended because it maps to the old well-known discard protocol whereas port 7 maps to the. I am trying to add nodes in MAAS cluster. Spiff is correct that it doesn't matter as far as the Wake-on-LAN functionality of the intended recipient goes.
0 Comments
Leave a Reply. |